Hiten's latest activity

Pardon me. i was not talking about working conditions. Just speaker voice coil placement. It needs to be perfect center and...

at 11.50... Surround, Cone, Spider Voice coil fixing at one go. Good Technique ? I was under impression that voice coil and magnet gap...

I don't see how an agreement between A and B mitigates a threat to either A or B coming from C.

This seems to be an ideal candidate for a minor crossover "mod"....a 1.5-2 ohm resistor added to the tweeter, would solve the impedance...

The stress here is entirely self-induced. Why the bloviation was taken seriously still eludes me. This is a lot of noise about nothing, IMO.

I am not talking about permission from manufacturer. But from the purchaser of the speaker who is owner. An explicit request for...

But if owner of the speaker has emailed the reviewer and said I want to test this, I understand your method/process of measuring and...

Wouldn't a properly worded disclaimer work ? And if any equipment owner sends any equipment an email of him/her requesting measurement...

(Image copied from earlier post of this thread. Is that Klippel stand ? ) Was the speaker previously measured like this ? if so, it will...

All these would have been not required if the speaker were designed in such a way that even if feets were removed it performs same. If...

Amir measures all speakers with care and rigour. And how old speakers are; does that matter ? Difference would be minor. (Compared to...

Yes. But the review has been taken off so I doubt if comparison would be possible. A clarification from Erin about how the speaker was...

I have built multiple larger platforms that I screw on top of Klippel to handle larger speakers. Otherwise you risk them toppling off...

The speaker in question is quite large, Feets are near the edge of speaker enclousre, and klipple measurement platform seems small (from...