Search results
-
Bluesound Node Replacement (DAC + Streamer + Preamp that delivers full volume)
I recently acquired a set of Ohm Walsh 2000 speakers which are being driven by a Buckeye amp that is based on Hypex NC502MP module that's 350w/ch @ 8ohms, 500w/ch @ 4ohms and I have been unable to achieve satisfactory volume levels. The speaker manufacturer recommends a 40-200/ch watts amp for...- Pixelhead
- Thread
- Replies: 17
- Forum: DACs, Streamers, Servers, Players, Audio Interface
-
Which Amp for Ohm Walsh 2000 Speakers (100-250 watts/ch stereo for under $1000)
I just acquired a pair of Ohm Walsh 2000 Speakers and need to figure out the best amplifier to power them from for under $1000. (I'm in Florida, USA). The manufacturer recommends amps between 40 and 200W, but said they'd much rather me overshoot that range that end up with an underpowered amp...- Pixelhead
- Thread
- Replies: 22
- Forum: Amplifiers, Phono preamp, and Analog Audio Review