Search results

Hi @glc650 , Great idea to use the Pre90 as a switch box as the Flex doesn’t have ht bypass feature. I use a high quality passive xlr switch box, but it doesn’t have remote control. Does the pre90 have remote control? Do you use the pre 90 with fixed gain input? (I assume you use flex’s volume...

Hi @SubsonicLurker , I saw that you are retiring your old big Emotiva. I am having the same problem. I have an old Parasound A21 amp. How the Vtv compares with the Emotiva regarding SQ?

I meant that is has four channels on the output. You will have 4 setings for the four outputs.

Hi @SubsonicLurker Thanks for your explanation. I was planning to buy it with the sparkos I/o. Have you heard it? Thanks

Hello, Sorry for the newbie question, what's the difference of the vtv's 1et400 and Eval1 models?

Hi, I think the flex is a 4 channel device.

MiniDsp shd and Flex séries main use are for 2.2 and 2.1 stereo músic listening.

I would do time integration between the mains and sub. You can use Alignment Tool in REW , you probably have to delay the mains. Remember to measure with time reference on. Then you put the delay value in the plug in, before run Dirac.

Hi, I strongly recommend you take a look at Minidsp SHD line of preamp/Dac/processor. You can use the extraordinary Dsp functions of it to integrate your sub (s) to your Mains.

It's incredible how a small and inexpensive amp can beat this monster...... Thanks Is it the same even at low volume?

Hi @peng , I have a A21 that’s in repair. I am a layman regarding Class D amps, and I would appreciate if you tell me how they compare with the A21. I have a Kef R300 speakers with 2 svs subs and minidsp SHD. Any help is welcome. Thanks

In 1 goes to speaker 1 In 2 goes to speaker 2 In 1 goes to sub 3 and sub 4 In 2 goes to sub 3 and sub 4 So speakers reeceive R and L respectively And the subs receive from R+L

In the drawing you sent before, just checked all four buttons of the 3 and 4 outputs

Regarding the position of the sub, I had the same misconception, again. I had always put the sub near the speakers, but in most cases these are the worst places to put the subs. Then I broke the rules and found in my living Roon places where the Bass was much better, near the sofas, near...

It’s not complicated, the Bass for the subs can be a inexpensive one, Topping D10 will fit the bill! Flex digital will be released in few months

I had the same misconception before. Bass is tricky!! If you send mono signal to both subs, you still be able to adjust the phase and delay of each sub separately. In minidsp phase and delay are controlled after the input, so no problems. The advantages to have two subs reside os the ability...

I prefer to have two subs in mono. So In1 and In2 both goes to 3 and 4 outs (all checked). I strongly reccomend use two subs and both receive L+R mono signal. It smooths out the Bass much better... Also put your subs Front and rear of the room in diagonal position.

You can also wait for the Flex Digital Only. Its the same as the Studio, without the streamer, and much cheaper (it has less processing power)

Sorry, I did not explain correctly: The SHD Studio has 2 digital outputs. One Digital output is stereo, so you have 2 dig outs = four outputs. But you have to buy another dac (could be a cheap $100 D10 Dac from topping). So the D90 goes to the main Speakers and the other DAC goes to the Sub...