Meetup scheduled for 1/20/24 at a members house near cave creek area. PM for address
4:00pm start time but I will be over there a little earlier with the JL max dialing in his system, so if you want to see how that is done, I will be starting around noon.
My ground loop path was coming from the cable coax and being transferred via the hdmi cable. I could never find the cause of the cable coax other than disconnecting it all the way at where the cable was coming into the house.
Agree that grounding chassis isn’t always going to fix it, but...
Nearly every time I’ve tried tying cases together it has lowered noise. Usually some stuff is using a two prong plug and some is using a 3 prong with earth ground. That’s usually when I see ground loops like this and when it has worked.
I ended up needing to tie chassis’s together to eliminate the noise by running a separate wire between chassis bolts on all equipment. That was what ended up solving my ground loop. Now I don’t even have any of that equipment anymore.
As far as the monoprice, I knew it did because I had that...
There is a review index on this site that is pretty good, although some reviews are missing from it too.
Also erins audio corner does reviews and has quite a few center channels. He also has a klippel nfs.
Each module has its own power supply in these amps. So power available is solely based on your wall power availability. If you have adequate wall power available, the. It could produce all the rated on all channels driven.
This Saturday (10/7/2023) @ 6pm.
Meeting outside of State 48 Funk house in westgate
6770 N Sunrise Blvd, Glendale, AZ 85305
https://maps.app.goo.gl/Z7SMGf5NijTmag5Y8
Then over to a members house to check out his chane speakers and hsu subs (cars will be there too to check out if you want!!)
Pin 1 is connected to case ground in that diagram of hypex. You can see a little wire on the case side coming from pin 1 to the case.
Now the pin 1 being connected to the "4th" connection of the xlr (the metal casing) can be debated, but that just connects to case ground too....so shouldn't be...
Sorry for the late notice, but meet up tomorrow!
Lets meet here this Saturday 8/19 at 9am if that works for all!
First watch 3110 N Central Ave, Phoenix, AZ 85012
https://maps.app.goo.gl/7PmfLyyJcRi5s69f9?g_st=ic