eddantes

Flat response, low distortion, and an agnostic attitude towards load impedance curves. ;) Low noise is probably a good idea too, in case...

It doesn't matter if you can tell... For "normal people" - once you realize how minute the differences are, then diminishing returns...

If you want value (with very little risk) you buy used - speakers are very robust products with great longevity (unless you are buying...

Wow that looks great! I'd be chuffed to bits if my result was this close. Actually - for this past project, I did measure the DCR of...

Thanks for your reply. I just built a small pair - but my Vcad sim and measurements are really off. Speaker is still a good one - but as...

I ususally look at f6 or f10 considerng room gain effect. According to simulations f6 should be 42Hz but it's actually around 55Hz which...

Another take on a small two-way monitor design. While searching through various datasheets, I came across a driver setup that seemed to...

Nice! What's the F3? Any idea of max SPL? Both Z at 0? I'd say woofer is at +10 to the tweeter.

It's not the main direct sound that we want blurred, it's the reflections. In other words, we don't want specular reflections, we want...

Smother it with hot sauce!

Other than Rosalia (for it's sheer audacity, though I hate when lyrics use swear words) none of these are my speed. But - it was...

I am not the official vote counter, but I was curious so here's what I analyzed from the 2025 Music Discovery Award thread. I only...

No notes

Wim Amp Pro - flexibility you need and sound quality too. (Unless you need more than one RCA in)