- Thread Starter
- #41
Thank you so much for the review.
Do you have a chance to do some measurements in non-direct mode?
Considering the target audience of this device, this amp would unlikely be used in Direct. Older r-n803 has severe degradation in 'Normal' mode.
Good point. After purchasing the R-N1000A last year, I immediately compared Normal mode and Pure Direct mode. Unfortunately, the graph below contains significant noise due to another cause (excessively high volume), but I think you can see the relative differences between Normal mode and Pure Direct mode.. THD+N was about 6dB better in Pure Direct mode than in Normal mode.
This difference was in the noise (N) component, not the THD; there was no significant difference in THD between Normal mode and Pure Direct mode.
Also refer to my previous comment on Pure Direct vs. YPAO.
https://www.audiosciencereview.com/...a-network-receiver-review.67197/#post-2441738
Last edited: