Nobunaga
Member
Hello
I want to solder a USB type-B connector on my Khadas Tone Board, Khadas confirmed to me that it's possible to use the 40pin header for that.
But i don't know which of these 40 holes (pins) are the ones i need for an USB 2.0 port.
Could anyone mark them for me?
Best regards
I want to solder a USB type-B connector on my Khadas Tone Board, Khadas confirmed to me that it's possible to use the 40pin header for that.
But i don't know which of these 40 holes (pins) are the ones i need for an USB 2.0 port.
Could anyone mark them for me?
Best regards