Waveguide 3d Plac for Scan Speak D3004/662000 or D3004/6600 anyone?

[DrSpan]

Hello there.

I am looking for a Waguide 3d design that has been proven and measured in real life for the scan speak 25mm Tweeter.

It has this „special“ front plate so it needs a customized design i think

Only one i have found is Somasonus but it is a tad too big. I would ideally find one that is 4inches in overall diameter or 104mm

Does anyone here has ever done this? Or do you have any tip as to where i can find something?

 

[J49]

Scanspeak D3004/6600 | somasonus

www.somasonus.net

Looks like the first version is 4in

 

[DrSpan]

Scanspeak D3004/6600 | somasonus

www.somasonus.net

Looks like the first version is 4in

Hi there.
I have looked at the Somasonus. Unfortunately even though it is called 4 inch in real life the design is resulting in 121mm which would be 4,76 inches.
4 inch is around 10+ cm.
I am looking for a waveguide that is only marginally bigger (1mm) in diameter than the original plate which is 103.5mm

 

[CristianoLO]

登录 Facebook

登录 Facebook，与好友、家人和认识的人分享和建立联系。

www.facebook.com

Seams to be the same type of adaptor needed for Peerless XT25GB60 and XT25TG30
If you take some dimensions, we can check it and create a custom design for it