guitarshredda15
Member
- Joined
- Jan 28, 2019
- Messages
- 58
- Likes
- 29
Looking for some opinions/advice from Version 1 owners.
I got my DX3 Pro at the end of 2018, used it for a few weeks and then read the stories of loud bangs, blown headphone drivers and quite honestly I became nervous and stopped using the unit (I didn't want to risk my headphones and I dislike loud, unexpected sounds) so I went back to using my Focusrite Solo as my main listening source.
I left the unit plugged in the whole time and now I'm considering using it again. I'm really intrigued to find out if there are there any Version 1 users here that are still using their original units with headphones, without any faults rearing their heads?
My headphones are PSB M4U1
Impedance 32 Ohms
Sensitivity 1kHz/1mW 102dB
Not sure if the headphone specs made any difference in terms of what caused the blown headphone output issues...
Hi there. An old user here. Purchased my unit back in early 2019 (V1). Besides some oddities that have occured in the last 2 years with the unit, it's still going! I use it every single day, either with my powered monitors or most often IEMs. Use both USB and bluetooth. I think my issues were ground loop related which I posted about in this very thread, which you can read about in the older pages. Its a solid unit, at least mine has been. I have no desire whatsoever to buy another amp/dac and will keep using until it finally dies on me which could be a long time from now!