This is a review and detailed measurements of the Okto dac8 stereo DAC. It was kindly sent to me by the company for review. It costs €1 089 from the company ($1,240 as of this writing). The version I have has the optional Raspberry Pi 4 module for streaming which costs an extra $89.
Last I tested a dac from
Okto, it was their prototype 8-channel DAC. It set a new record in our measurements at the time, getting the highest "SINAD" score possible. While I loved many things about the hardware design, the case needed a new color and thicker sheet metal. Happy to report both of those have been managed producing a very professional and nice looking DAC:
View attachment 73312
As with the last model, the interface is a joy to use with large, bright text that changes lightning fast. An apple remote is provided for control which I used to good effect to navigate the menu system.
The back panel is quite unusual for a DAC:
View attachment 73313
For starters there are dual set of XLRs so that you can use them to connect to two sets of devices (active speakers and a pre-amp). We have two pairs of coax and toslink instead of usual one.
Streaming is provided by Raspberry Pi and while it is physically integrated into the unit, requires that you use the jumper to wire up the dac to its USB output. Fortunately you have another USB input so you don't have to take this in and out.
My unit came with a copy of Volumio software on the SD card which let me stream to it using Airplay. Sadly Airplay only supports 16 bits/44.1 kHz so severely impacted the performance. You can of course change that to another streamer software (e.g. DietPi) or install the Roon endpoint to get full 24-bit streaming at various sample rates.
So I would say the streaming functionality is less than perfectly integrated but as much as they could given the platform restrictions.
DAC Audio Measurements
Competition has gotten quite stiff since I tested the original okto DAC8. Can the new version unseat all the others considering that we are almost at the limit of what my analyzer can measure? Let's find out:
View attachment 73315
Darn it, it did it!
View attachment 73316
View attachment 73317
Yes, the output voltage is a tad high (4.2 vs 4.0) volts which probably helps a bit here. I dialed it down 0.5 dB and it essentially held its performance.
Note that actual performance is better than this as we are including the noise on the input of my analyzer in what the DAC is producing, hence my comment that there is not much more room left to get higher scores.
Speaking of noise, here is the dynamic range:
View attachment 73319
Intermodulation distortion and noise is exceptionally low as one would guess:
View attachment 73320
Multitone as a result is clean as well:
View attachment 73321
And oh, in case you want to use the unit at lower output levels, here it is:
View attachment 73322
So the higher the better but even at just 0.8 volts, you have a SINAD of 110 dB.
Linearity is nailed showing superb accuracy:
View attachment 73323
There are five filters with acronyms I did not try to decipher:
View attachment 73324
Extremely good attenuation for out of band spectrum helps with excellent THD+N versus frequency using 90 kHz bandwidth:
View attachment 73326
Jitter over USB is extremely good:
View attachment 73327
For some reason though, there is some jitter with Coax but not with Toslink or AES/EBU:
View attachment 73328
Headphone Amplifier Tests
I ran a couple of quick tests on the headphone amplifier and was pleased how good its performance is, no doubt helped with such a clean DAC upstream:
View attachment 73329
View attachment 73330
There is good amount of power there but not enough to drive the most difficult headphones.
Edit: added streaming measurements.
Streaming Performance
The unit as supplied was running Volumio. I was pleasantly surprised that the Volumio UI has been enhanced to easily install extensions such as "Roon Bridge" which I used for the following tests:
View attachment 73956
As we see performance is identical to USB which is great. Same is true of jitter test:
View attachment 73957
There is no degradation whatsoever when streaming instead of USB.
Conclusions
okto has done it again: producing state-of-the-art, class-leading, instrument-grade DAC. Not only that, the mechanicals and usability are a good match for it as well. When someone as picky as me can't find any faults, you can tell the job is well done. Very well done.
It is my pleasure to highly recommend the okto dac8 stereo DAC.
------------
As always, questions, comments, recommendations, etc. are welcome.
You would think after seeing such stellar measurements, I would be so happy to not demand more donations. No way. A man would not be a man if more money didn't make him happier. So please
donate some money my way using
: https://www.audiosciencereview.com/forum/index.php?threads/how-to-support-audio-science-review.8150/