@jj-wohlgemuth
I have found the problem.
I have
- RME ADI-2 DAC on USB with MADIFACE driver. It is switched off, not used.
- Focusrite Scarlet 2i2 with driver - this I have used only for calibration. I works also with version 1.3 - just did it.
Last time I bought RME Fireface UCX II with Fireface USB driver. I wanted to use it also for calibration and sell Focusrite. But MA1 doesnot work with it. I dont know where incompatiility is but almost sure on Neumann side. Any other softvare works with it. Only MA1 does not.
Or it has something to do with fact I previously used Focusrite and MA1 remembers it somewhere and tries to find it again but it is not connected so it hangs. If somebody is using the same interface all the time - MA1 works in this case.
Please correct this, it costs me money for Focusrite and really lot of time with buggy MA1. I am a sw developer and see this sw is still not well done after so long time.
And this new saved HW setup - this is only cosmetic change not much usefull, it was always saved, but we need to save mainly RESULT of alignement on hard disk not input values like monitor ID and network card. And restore of course. And possibility to set oher parameters without need for recalibration. This is saving lot of our time.
I have found the problem.
I have
- RME ADI-2 DAC on USB with MADIFACE driver. It is switched off, not used.
- Focusrite Scarlet 2i2 with driver - this I have used only for calibration. I works also with version 1.3 - just did it.
Last time I bought RME Fireface UCX II with Fireface USB driver. I wanted to use it also for calibration and sell Focusrite. But MA1 doesnot work with it. I dont know where incompatiility is but almost sure on Neumann side. Any other softvare works with it. Only MA1 does not.
Or it has something to do with fact I previously used Focusrite and MA1 remembers it somewhere and tries to find it again but it is not connected so it hangs. If somebody is using the same interface all the time - MA1 works in this case.
Please correct this, it costs me money for Focusrite and really lot of time with buggy MA1. I am a sw developer and see this sw is still not well done after so long time.
And this new saved HW setup - this is only cosmetic change not much usefull, it was always saved, but we need to save mainly RESULT of alignement on hard disk not input values like monitor ID and network card. And restore of course. And possibility to set oher parameters without need for recalibration. This is saving lot of our time.