Hey everyone, I'm trying to figure out how I can add a couple of 6" woofers to my q100 in a larger box in order to relieve the mid and gain more low-end extension into the 60hz region. Currently, with my speaker in the entertainment center under the tv, it poops out at 100hz and my subs don't naturally reach that high in my room. Should I just eq the subs to do so? As I'm writing this I'm also realizing it might make sense to place one of my bookshelves that I know reach down to 40hz in the cabinet to see if the same issue persists, as no speaker will "fix" that issue if it's more placement dependent
Still, I think it would be pretty sweet to build my own larger "kef" q100 type, speaker.
Erinsaudiocorner already has so much data on the driver. Is this info all I would need to simulate box and crossover after adding 2 woofers?
how do I get the info into xsim for xo design?
Can you add more than a single driver to winISD to simulate the size of the box and port needed for bass extension?
Still, I think it would be pretty sweet to build my own larger "kef" q100 type, speaker.
Erinsaudiocorner already has so much data on the driver. Is this info all I would need to simulate box and crossover after adding 2 woofers?
how do I get the info into xsim for xo design?
Can you add more than a single driver to winISD to simulate the size of the box and port needed for bass extension?