As proof of the concept, I decided to make a clone of the LXmini speaker.
The results are excellent both audible and measurable.
The drivers I used are Mivoc swm 68 and TC9FD18-08 which in my opinion is a far better driver than Seas FU10RB (H1600-04).
I ordered the Seas L16RN-SL (H1480) waiting to arrive to make the final version.
If someone is an expert in designing parts for a 3D printer, they might be able to contribute to the design by designing the upper part that comes on the tube.
Off axis measurements are 0-22-45.
The microphone I use is Umik-1. It has a horrible feature to bring down the response over 18khz so I don't know the real situation above.
Crossover is terrible minidsp 2x4.
The results are excellent both audible and measurable.
The drivers I used are Mivoc swm 68 and TC9FD18-08 which in my opinion is a far better driver than Seas FU10RB (H1600-04).
I ordered the Seas L16RN-SL (H1480) waiting to arrive to make the final version.
If someone is an expert in designing parts for a 3D printer, they might be able to contribute to the design by designing the upper part that comes on the tube.
Off axis measurements are 0-22-45.
The microphone I use is Umik-1. It has a horrible feature to bring down the response over 18khz so I don't know the real situation above.
Crossover is terrible minidsp 2x4.