Bourneendboy
Member
- Joined
- Dec 1, 2019
- Messages
- 6
- Likes
- 14
I have a very nice aluminium case for the KTB for sale. This is a prototype case I was developing with an OEM case supplier, but have decided not to take the project any further.
The top is held in place with hot melt glue and can only be seen from the inside. The base is only fixed at the back by two screws, I had glued from the inside after fitting the board, again, nothing seen on the outside.
I don't think you could find a better case to be honest.
Excellent condition as can be seen in the photos.
Looking for £25 including UK postage.
The top is held in place with hot melt glue and can only be seen from the inside. The base is only fixed at the back by two screws, I had glued from the inside after fitting the board, again, nothing seen on the outside.
I don't think you could find a better case to be honest.
Excellent condition as can be seen in the photos.
Looking for £25 including UK postage.