Fosi v3 amp load dependency with Yamaha NX-E800 - an issue?

[wineaholic]

Hello,
can you guys tell me if the load dependency with Fosi v3 Yamaha NX-E800 speakers will be a problem? Or would this be a good combination?
tbh I don't actually understand too much about this matter.
I just want a cheap, good-sounding, energy-saving amplifier. (The Pianocraft systems that actually belong to speakers can be purchased for 50€ but consume 50W permanently)
thank you in advance

 

[staticV3]

Hi @wineaholic! Welcome to ASR.

We need the speaker's impedance response to predict how load dependency will affect frequency response.

Unfortunately, I was not able to find an impedance response measurement of the NX-E800.

Although frankly, I wouldn't worry about it.

The NX-E800's stock frequency response coloration is likely way higher than the possible coloration due to load dependency, so I doubt it'll be noticeable.

 

[wineaholic]

ok thanks the only way is probably to test it. It's just been reduced to 50€ on aliexpress

 

[Zek]

It's just been reduced to 50€ on aliexpress

Where specifically?
Make sure it's not a scam.

 

[wineaholic]

Where specifically?

here: https://de.aliexpress.com/item/1005005605031795.html
Its the official store

 

[Zek]

here: https://de.aliexpress.com/item/1005005605031795.html
Its the official store

Oh yes, with no power supply.