First Attempt to MathAudio Room EQ in Foobar2000

[Guddu]

Dear FMs,
I am using UMM-6 for measurements and uploaded calibration file to MathAudio folder before taking measurements.
I am not getting anything mids or high freq. captured there, as you can see in snap below.
Any suggestions what might be wrong here?

Many Thanks.

 

[Zoomer]

Did you follow these instructions mathaudio.com/room-eq.htm ?

 

[Ron Texas]

Sweep signal volume is turned up all the way. Did you blow your tweeters?

 

[Guddu]

Did you follow these instructions mathaudio.com/room-eq.htm ?

I did, looks like something with the mic because it gives same measurements in REW no matter where I place them, even when there is jo sound played through speakers.

 

[Guddu]

Sweep signal volume is turned up all the way. Did you blow your tweeters?

no, speakers are absolutely fine, I am suspecting issues with mic.

 

[Snarfie]

Try a measurment without a correction file

 

[Guddu]

Try a measurment without a correction file

I had a chat with Dayton Audio and they suggested to get a replacement, it was out of stock so had to get refund but will get another soon and try again.
Thanks.