I just got my amp case back from my friend who machined my front and rear plates, and installed the amp modules. I am now trying to wire the amp modules up, but I am having some difficulty. I appreciate any assistance anyone can give me, as I am in Mexico and have no outlet for info locally.
I have run the power wires from the PowerCon connectors to the Switch (not hooked up yet though). now for some questions on the power runs.
The amp only uses 2 wires for power and I am using a 3 wire power cord for each pair of amp modules.
1: Do I need to run a 3rd wire...if so where do I run it to from the Powercon connector?
2: Does it just go to ground, and get grounded to the case?
3: I am assuming that it is ok to bundle the power wires all together, but want to make sure.
4: Do I need to ground the amp modules to the case or is the brass standoffs sufficient for this?
Speaker hookups for BTL mode
Does anyone know how you hookup the wires... I am only using 1 channel as the amps are bridged BTL mode.
1: Do I hookup the + from one channel, and the Negative of the other?
Input wires... I am assuming pin numbers are read left to right.
1: Can someone tell me which pins on the amp module go to which pins on the XLRs?
I have run the power wires from the PowerCon connectors to the Switch (not hooked up yet though). now for some questions on the power runs.
The amp only uses 2 wires for power and I am using a 3 wire power cord for each pair of amp modules.
1: Do I need to run a 3rd wire...if so where do I run it to from the Powercon connector?
2: Does it just go to ground, and get grounded to the case?
3: I am assuming that it is ok to bundle the power wires all together, but want to make sure.
4: Do I need to ground the amp modules to the case or is the brass standoffs sufficient for this?
Speaker hookups for BTL mode
Does anyone know how you hookup the wires... I am only using 1 channel as the amps are bridged BTL mode.
1: Do I hookup the + from one channel, and the Negative of the other?
Input wires... I am assuming pin numbers are read left to right.
1: Can someone tell me which pins on the amp module go to which pins on the XLRs?