fritobugger
Active Member
Several months ago I got an X4800H to replace an aging X4200W.
I was very happy with it and all was well until I decided to bi-amp the main speakers.
This is using the pre-set configuration option of 5.1 (bi-amp) + zone 2. I am not using zone 2.
There was no power on pop with I was only doing 5.1 without bi-amp and without zone 2.
The pop is not loud and sometimes doesn't happen. I am guessing the pop only is happening when the amp is cold. If I shut it down and then power it on again after running for long enough to get warm/hot, it sometimes/often doesn't happen at power on power.
Please note this is pop heard coming from the main speakers not the click inside the amp.
My google-fu has not turn up anything and I am not a participant in any Denon forums.
I was very happy with it and all was well until I decided to bi-amp the main speakers.
This is using the pre-set configuration option of 5.1 (bi-amp) + zone 2. I am not using zone 2.
There was no power on pop with I was only doing 5.1 without bi-amp and without zone 2.
The pop is not loud and sometimes doesn't happen. I am guessing the pop only is happening when the amp is cold. If I shut it down and then power it on again after running for long enough to get warm/hot, it sometimes/often doesn't happen at power on power.
Please note this is pop heard coming from the main speakers not the click inside the amp.
My google-fu has not turn up anything and I am not a participant in any Denon forums.
