Crown XLS 1502 pushrod come off

[Ausghostdog]

Hey all,
Have a pair of 1502s, just turned them on and the pushrod, seems to have come off and fallen into the case, can see in the thread below amirm, down a tear down, it appears to get it open I just need to undo the screws at the back and slide the case of?

Crown XLS1002 Amplifier Teardown

I recently reviewed the Crown XLS1002 Amplifier. This is a teardown of the same. Let's get right into it with the overview shot: A single board contains the entire guts of the machine, sans the front panel display. Using one board lowers labor cost and increases reliability due to...

www.audiosciencereview.com

anyone done this before, any tips ?

 

[Redacted]

I can't help, but a few screws are surely no big deal? Don't break any plastic lugs when sliding the top of though (if there are any)

Looking at the pic, the "nice mechanical switch" may be fine, but the offset double-bent pushrod is an obvious masterpiece in idiotic design!
.
.

 

[Ausghostdog]

If anyone finds this in the future you need a t15 screw driver, and the push rode slide back over the white bit, was a pretty easy fix