• Welcome to ASR. There are many reviews of audio hardware and expert members to help answer your questions. Click here to have your audio equipment measured for free!

Crossover and phase importance

Crossover simulation based on actual polar measurements of the drivers in a prototype cabinet
Is there smoothing applied? Smoothing can make the null look less deep. If this is the null out of phase and the summation of the two curves is 6db when they are in phase then it would be good.
 
Is there smoothing applied? Smoothing can make the null look less deep. If this is the null out of phase and the summation of the two curves is 6db when they are in phase then it would be good.
The vituixcad '6-pack' image in the first post is the the same crossover. Frequency responses were smoothed to 1/48th when exported from REW to vituixcad. This last image is the same circuit but now with reversed polarity on the tweeter to show the null.
 
Actually improved it quite a bit :)
New solution Six-pack.png


And with the tweeter polarity inverted:
New solution SPL.png
 

Attachments

  • Best solution SPL inverted.png
    Best solution SPL inverted.png
    41.2 KB · Views: 23
Well done, you learned to give the xover a fitting frequency and attenuation for the drivers.
Here we go.
 
Back
Top Bottom