• WANTED: Happy members who like to discuss audio and other topics related to our interest. Desire to learn and share knowledge of science required. There are many reviews of audio hardware and expert members to help answer your questions. Click here to have your audio equipment measured for free!

Buckeye Purifi Eigentakt 1ET9040BA monoblock power amplifier Stereophile Measurements

Status
Not open for further replies.
Yes,their old budget one must be a benchmark along with the small Yamaha's for entry level audio back in the day.
And they are stil around I think,one can;t miss their ugly case :p
Yes, they have a very bland appearance. I'm not a fan of the design of their older budget offerings, but I do like the look of their Master and Silver line series.
 
And soon we'll have more data to show once revised testing is finished. Feel free to check back then if you are still concerned.
The measurements you and James were referencing -where can I find those? I looked around but couldn’t find them.
 
The measurements you and James were referencing -where can I find those? I looked around but couldn’t find them.
About halfway through the official 9040 thread in the Dealers section. I wouldn't call them final results, however, because we ended up returning the AP unit we had been using due to an issue. That's its own story and not on topic for this thread.
 
my experience with them has been positive in terms of delivering a lot of power for the price. That said, I don’t have any experience with their newer class-D models.
NAD seems to get the maximum out of the Purifi modules by using adequate PSUs. I have never seen the values shown here at 2 and 1 ohms from any other manufacturer: Link
To me, it seems all the more important with new Purifi implementations that the PSUs perform accordingly over the entire frequency range!
 
Do not forget that your link leads to short-term power, “dynamic power” measurements. Not much telling about PSU.
 
Do not forget that your link leads to short-term power, “dynamic power” measurements. Not much telling about PSU.
Really? I assume that the standard Hypex modules installed in other 1ET400A implementations cannot provide this short-term performance.
This should also be considered/counterchecked with 9040 implementations.
 
I don't think its unreasonable to ask Buckeye to change the misleading information on his website.
You making the same point repeatedly is badgering and unacceptable. What Buckeye does or doesnt do with their website is up to them. Vote with your wallet if you don't like that but your overall tone on this site is confrontational and wearing thin .
 
Last edited:
Status
Not open for further replies.
Back
Top Bottom