- Joined
- Sep 19, 2019
- Messages
- 456
- Likes
- 306
Hi all,
I am currently using AVR RX-V775 mainly for movies streamed via Apple 4K TV and use its pre-out for my Genelec active monitors 8340 LCR & 8330 in 5.2 set up with 2 SVS 12" subs. Since I am using GLM software in Genelecs, I do not want to use the EQ of Yamaha AVR and hence I have set the "Parametric Eq" to "Through" which means AVR does not use the equaliser. I am normally using the DSP - Surround Sound Program "Standard Theatre" for movies.
Few questions:
Many Thanks for the help!
I am currently using AVR RX-V775 mainly for movies streamed via Apple 4K TV and use its pre-out for my Genelec active monitors 8340 LCR & 8330 in 5.2 set up with 2 SVS 12" subs. Since I am using GLM software in Genelecs, I do not want to use the EQ of Yamaha AVR and hence I have set the "Parametric Eq" to "Through" which means AVR does not use the equaliser. I am normally using the DSP - Surround Sound Program "Standard Theatre" for movies.
Few questions:
- On one hand I do not want to use AVR EQ and on the other hand DSP seems to be mandatory to get a good surround effect in the room. Should I continue to use DSP "Standard Theatre" mode or should I use the "Straight option" which will use the dolby decoding of Apple 4K TV?
- Attached are some pictures. I am not sure which of these settings will use EQ and which ones not? Any one have any recommendation to not use some of these so as to not mess with the GLM EQ? Especially the ones I am bit skeptical are
- Sound: Dynamic Range, Adaptive DSP Level
- Sound Program: Decode Type, DSP Level, Sorround Initial Delay, Surround Room Size, Surround Liveliness
- Option:Tone Control (Bass), Adaptive DRC, Cinema DSP 3D mode, Dialog Adjust, Volume Trim (Bass)
- For movies, sometimes, the dialog level is low. Should I use the Dialog Adjust - dialog level 0-3 option or should I increase the volume gain of Center speaker? Which is better and not Mess with Genelec EQ.
- I am using MiniDSP DDRC24 DIRAC for sub correction. Is it recommended to run YPAO again after DIRAC to get the final tuning?
Many Thanks for the help!