Audiolab 9000p bridge mono help

[Zastawny4475]

Hi all this is my first post.
I need sum help with runinng the audiolab 9000p amplifiers in bridge nono mode with my q acoustics concept 50 speakers.

As i understand running two of the 9000p amps in bridge mono they see half the impedence of my speakers nominal is 6ohms dips to 3.6 ohms. Would the two 9000p amps be ok to handle the dips down to 3.6ohm even lower i guess if bridge mode halfs impedence. Thanka

 

[LTig]

Bridge mode does not change the capability of each individual amplifier. Each amplifier sees half the impedance of the speaker and hence must deliver twice the current compared to non bridged mode.

 

[Chrispy]

Why are you doing this?

 

[Zastawny4475]

Why are you doing this?

Wanted to see if it was possible. With my speakers. Is there no benefit then? Using two 9000p amps thanks.