input sensitivity

hi there, i was wondering if anyone knew the specified or recommended input sensitivity for the kef kc 62s? i assume something like +4dbu, which is what given them. but maybe someone knows? thanks, christian

I hope this is the right forum to ask this. I'm getting too much distortion from my miniDSP flex into my Rotel RB-1552 power amp (130 watts, 1.5volt input sensitivity) in a medium sized room. Apparently when using Dirac Live you're not supposed to turn the Flex up past -10 so that Dirac can...

Hey All, I am purchasing a pair of the Klipsch Jubilee that have an active crossover and I am struggling to consider what I need to do to yield the best signal chain. I asked Klipsch at what input voltage their crossover clips at and they didn't have that data. All they said was its...

Please help me understand the math around; output voltage of a Pre, Input Sensitivity of a Power Amp, how to find out the Gain of a Power Amp, and help me understand what can one do with that information, and how can it help me with choosing a pairing. I will be choosing either a Denon/Marantz...

Hello ASR, thank you in advance for answering my silly question. I have a hunch that this has been standardized in the industry, only that I'm not good enough at googling. As we know, there are two ways wave-forms add: for coherent ones, two equal signals in phase adds into something with 2x...

In my home theater, the L+R speakers are Acoustic Research (Teledyne) AR9 driven by an Adcom GFA-585 amplifier while the C speaker effectively is the top section of an AR9 driven by the bridged channel of an Adcom GFA-2535 crossed over at 200Hz. Audyssey XT32 on my Denon AVR-X4000 balances...

Hi, Team. Wondering if there is a rule of thumb here, in terms gain matching your prepro and amps, in a separates config…. I have a very poor understanding here. I read about clipping, and ensuring enough voltage on the pre-outs to enable max output from your amp. Is there not protection built...