Search results

I hear wavecore.

I'm in, please let me know the payment details

Is it still available?

Could you add pics? Any idea on the shipping cost for the A30?

You still need a server and a client, you can run the server in the same Raspberry. Picoreplayer has a quick/easy setup to do so.

Were these sold?

The hypex modules have a standby mode and need to have an enable signal to fully power on. If the amp only has a single power button the enable is shorted. So the trigger is usually a switched jack. Nothing connected keeps it shorted. You connect something, that something must provide the...

The trigger is as you mention for standby/on. If you want to turn it off, you need access to the back switch.

https://m.imdb.com/title/tt1050160/ Machine girl.

Is this in the US?

The shitt modius or the drop grace balanced are not that expensive. https://www.audiosciencereview.com/forum/index.php?threads/review-and-measurements-of-grace-design-balanced-dac.8201/ https://www.audiosciencereview.com/forum/index.php?threads/schiit-modius-balanced-dac-review.13769/

Basically you need higher input voltage, depending on the laptop, you might be limited below 1.9v. So I would recommend a balanced DAC to be able to get the best of your amp.

I'm using a smart plug and the source (raspberry) runs a script that turns it on or off.

I use a S8 with a PI with no issues.

Yes, it does.

if you use LMS you can install the Spotty plugin and you load tracks, albums with no issue.

Main limit would be power. That said, I'm using a s8 in my desk. It works well.

Raspberry PI---Topping D10---DIY NC252mp---DIY speakers Raspberry PI---Hidizs S8---Senn HD598

Madisound carries the fusion amps, not sure if they carry the FA251.

From the datasheet: So blue is non inverting, "gray" is inverting and black/bare copper is ground. So you want blue to pin 2, "gray" to pin 3 and black/bare copper grounded to chassis, ideally not in the same spot you grounded pin 1. But if not doable, they recommended going to pin 1 for UcD...