Search results

Hi all, for Marantz NR1200, why audio.com has low output power at 4 ohms (around 50 watts) compared to Audiosciencereview's member oal getting almost 100 watts ? There is no speaker impedance switch on back panel as mentioned in audio.com website. Audio.com oal Link 1 Link 2

Hello, any chance some one has Mackie MR624 II service manual or schematic ? Links will also do., Best regards.

Hi all, has any one seen or read Mackie MR x24 series monitor measurements on web or magazine ? Can you provide any links ? Just comparing different brands and have not seen any on the web. Thanks.

Hi, why do some speakers have more compression. Is it due to box+port design combined with driver design ? for example Jamo klipsch i dont remember exactly but I have read about compression even in three way speakers. If it is about driver design does more power handling means less compression...

Hi all, trying to understand thd+n charts. Pl. take a look at following. (Charts are from audio poland website of Denon and Emotiva amplifiers) Am curious why some charts starts (0 or 0.1 Pout) higher and some lower. Is it because of Noise measurements are combined with THD measuremens ? what...

Hi, in multiway speakers it is said that for mid range 3/4 inch driver are ideal. Larger than this size it will beam. I see lots of studio monitors with 7 to 8 inch driver. so... 1) how do these designs manage directivity ? Compared to passive speakers, mostly I see the studio monitors have...

Hello everyone, I have very basic knowledge about electronics. This is my fun, getting hands dirty, Kill time during lockdown DIY. This is cheap money saving build (Cost me approx $ 90 Total). Sound is good and I enjoyed building it. Do suggest if any gross mistakes. Sharing some pictures...