Search results

You might want to scroll back up and read post #3.

All the EQs are all based on the same data from this review: https://www.audiosciencereview.com/forum/index.php?threads/genelec-8010a-powered-studio-monitor-review.16866 As staticV3 pointed out, you can ignore the GEQ if you've got access to PEQ software. The 'AutomaicEQ' is made up of AI...

Do you have measurements of the channels being driven simultaneously?

Only if you disregard the channel balance measurements.

Use whatever tools you have at your disposal. It doesn't matter if you use Audyssey or a GEQ. What's most important is that you don't boost frequencies in the midrange and treble before you can get your hands on some anechoic data to guide you in making an informed decision.

You could make your own quasi-anechoic measurements: https://www.audiosciencereview.com/forum/index.php?threads/how-to-make-quasi-anechoic-speaker-measurements-spinoramas-with-rew-and-vituixcad.21860 Even if the speakers are flat on-axis, they might have a directivity error causing off-axis...

The midrange is also being equalized. You speakers might very well be too bright, but it's better to use anechoic data to correct them. An appropriate RT for music listening is also an appropriate RT for conversing. I think you should (re)consider if you have struck the right balance between...

You risk degrading the sound quality when you EQ the in-room response to a target curve above the transition frequency. Here is one example: https://www.audiosciencereview.com/forum/index.php?threads/eqing-to-harman-curve-doesnt-give-me-pleasing-results-why-not.45861/page-2#post-1635398 You...

FWIW: https://www.spinorama.org/help.html

Caveat auditor.

That doesn't sound right. Can you post the RT measurements, please?

Considering its worst-case distortion level is at -80 dBFS before clipping sets in, it's a bit of a stretch to claim the measurements show an audible problem.

Yes, EQ is the only thing that can effectively address room modes. You need to measure both speakers again at the same time, preferably using the MMM method. Instead of CSD, you have to use the regular in-room response with a 50 dB vertical scaling and Var smoothing to create the EQ filters...

beyerdynamic DT 900 PRO X

Because, if you read past the poorly phrased poll question, OP is actually asking about equalizing the in-room response.

I would have to disagree considering how Back to Black is mastered.

https://www.dropbox.com/s/lpakp0jc4deruwr/Hifiman%20Arya%20%28RME%20ADI-2%20preset%29.pdf

Did you click 'Match response to target' again after changing 'Flatness Target' from 2 to 1 dB?

Assuming the speakers will be placed on the desk in the top left corner, I would swap its position with the closet in the bottom left corner, then pull it away from the wall and closer to the middle of the room in order to minimize adjacent boundary effects and mismatch in arrival times of the...

Unless you've found a good deal, a pair of XT60 is going to cost $500, leaving no money for a center channel. S807 is very bad: https://www.erinsaudiocorner.com/loudspeakers/jamo_s807 S809 and S83 haven't been measured, so I can't recommend those either. The fact that your receiver can output...