Search results

Yes, only a small red dot light (standby) is on, and all the display other than that is turned off.

http://www.tpdz.net/newsinfo/391293.html Above is the link for latest firmware V1.08

Allow this very low noise switching power supply to feed my E30, for me, I would say it made me happier than those DACs costed 3 or 4 x expansive more.

I went through my DSD64 files to E30 without any problem, and it sounds well.

Noted and many thanks.

Could someone tell me, if the Coxial input of E30 can accept DoP signal? Thanks.

I do believe that E30 could turn off the display with the firmware upgrade. Nevertheless, E30 is sounding better after a few days run-in, and proved what the others said : it is very sensitive to different types of power input.

No idea if USB power supply caused noise or not, since I connected my E30 with the 5V LPS supply. It was dead silent.

BTW, it sounds very nature when fed with DSD64 directly without issues. Very enjoyable DAC at such low cost. What a pitty that we can't replace the OP amp as D10.

My E30 arrived yesterday too. The firmware was 1.06 and I updated it to 1.07 immediately. Hooked up with my audio gear, E30 sang quite impressive and had no 'pop' sound issue. Sound wise is excellent regarding it's cost with wonderful sound stage & a bit warm middle-high. Thanks all for the...

Oh, Topping is a reputable company who really concern about the customer.

Thx. Just ordered E30 and waiting for the shipment. Will report my findings on this DAC.

Thx, BTW I connect to my integrated amp most.

So how is the pop sound? Did it still exist? Thx. If the pop sound solved, I will order E30.

According to the driver instruction, would like to suggest as follows: 1. the PC MUSS have the driver installed and worked, 2. to link the E30 to the PC WITH POWER ON first. Not sure if this could be done.