Search results

Just a "check question": does the MA-1 room alignment remain stored in the DSP after a firmware update and a subsequent reboot, or does a new measurement have to be performed?

I admit that one KH750 to a pair of KH150 helped me a lot, because the music I listen to is mostly rich in deep acoustic bass. My sound goes from the RME ADI-2 DAC FS to the SW and then to the KH150, all perfectly aligned with the MA-1 and thanks to it the presence of the SW is not noticeable...

Thank you for the tip! I'm quite good with soldering, so I can actually make such a cable myself... ;-) Rather, I was worried that there would be no problem at the output when the reducer (or cable) connects the minus of both channels (cold) to ground.

Hello, I am very interested in the ARC Studio, but one of the applications of use is in the living room, where I have an older but great-playing NAD C320 amplifier. I would need to equalize the acoustics of the room using ARC Studio by connecting it in the amplifier between the PRE OUT outputs...

Hello, I have a question. Does the MA1 program update to v2.2.1 automatically in the program, or does it have to be manually downloaded from the Neumann site and forcefully reinstall v2.1.1.800 to the new version? It was on v2.1.1.800 that the program offered me an update, but not on v2.2.1.

Hello, I have a question. Does the MA1 program update to v2.2.1 automatically in the program, or does it have to be manually downloaded from the Neumann site and forcefully reinstall v2.1.1.800 to the new version? It was on v2.1.1.800 that the program offered me an update, but not on v2.2.1.