Search results

Exploded view

I had a tweeter go out on my R263 tower. Harmon was able to send a replacement, as well as an exploded assembly view. I have hit a dead end removing the wave guide and bezel. Does anyone know how these are attached, how to remove them and replace them. Thank you much.

I am using the v3 monoblocks with my a130s. It sounds fantastic!

Ah yes, way back before Randy was inducted into the audio shill hall of fame. He is among my least favorite and least credible in the sea of paid youtube reviewers. I did like his channel back then.

I took mine apart and had a look. Everything seemed to be wired correctly. Is this an issue where the tweeter is out of phase with the woofer? If so, how would switching the wires at the terminal fix this? I'm always looking to improve my system. Especially when it's this easy.... and at...

I had the same question. For me, the survey was unavailable on thr kickstarter app. Once I logged in from a web browser, I could view and complete it.

I have asimilar setup and plan. Using a Dennon 3400. I'll be using the LCR single ended preout to drive 3 V3 mono for the front stage. Additionally the balanced output from the DAC can be used for a pure 2 channel experience. I Imagine I'll use the RCA pre-outs more often than not, as I...

Yes.

They collect info at fulfillment.

Because the Hyoex Nc252 modules would be the closest in price point. They are stereo modules. It would be a pretty good step up in price to go with three single channel modules.

Thank you. I was looking at it completely backwards. Like what could it possibly do to the subwoofer. Thanks for expanding my understanding and saving someone from my hasty response.

This would explain the problem with simultaneous low and high level hookups. But when running only speaker level connections to a subwoofer, how can the subwoofer or speaker for that matter differentiate a bridged amplifier from a non bridged?

I guess you could adjust the sub output to match your 2 channel, and let the avr processor do the equalization for the multichannel. Just a flip of the switch between sub inputs.

In my theater setup(Denon x3400) I crossover everything at 80hz as I have some decent subs(Monolith 12's) and want to take as much load off the amplifier. I will be using three v3 monos for the front stage. My plan is to continue to use the crossed over sub outs for everything. I will also...

Is this not specifically for connecting LFE(line level sub out) and speaker connections simultaneously? Do you even have a line level sub output? Under what circumstance would someone want both LFE and speaker level inputs hooked up simuopiniously. Obviously the manufacture saw a case, but I...

Edit! I was wrong. I was thinking about the subwoofer, not the amplifier. This could possibly damage the amplifier.

I think so! I am currently using a $200 SMSL AO200 for my 2 channel setup. If I remember correctly it rated at an honest 7owpc into 8 ohms. It sounds significantly better than my $1200 Dennon avr 3400x with a fluffed 100wpc channel rating. That being said, the fosi measures much better...

I have an unopened tube of TF8 I was planning on using. Is thr mx-6 much better. I mean it's only $10 for a 4g tube, but if the TF8 fits the bill I'll use it . Also it's probably going 2 years old, but unopened.

Thank you! @Fosi Audio. Could you please post the same information for the 5A power supply? I'm interested to see if the ripple spec is equally good. Impressive!

Darko is an epic wind bag, some kind of bag anyway. Sorry I couldn't watch through all of this. I however, wanted to leave my two cents. Although it is more than his pomposity deserves. Pretty much everything I dislike about the stigma of "audiophile" is epitomized by John Darko.