Search results

Haha, will do! Since I would need some kind of enclosure too, I think I might actually buy this one that I linked above: And then replace the trafo and PCB with these (but the 50053K, which is 2x15v) and connect an outgoing cable with a 3 pin DIN instead of a socket: This actually feels doable.

Thank you so much for the links and explanation!

So if I would get something like this: https://www.farnell.com/datasheets/3170001.pdf Then I would connect Red to Pin 1, Yellow to Pin 3 and join Black and Orange (or just one of them?) to Pin 2, correct?

I showed my latest image to ChatGPT, and I’m amazed that it understood the whole thing:

And an ugly drawing of the components seen from underneath along the traces: Does all this then mean that 15+15=30 V DC will be going out on the red wire?

The rectifier from both sides, one flipped so things line up.

Since one of the black wires and the orange wires both go to the power switch and then to the fuses, shouldn’t that be 15 V och each of those two, with the second black wire for 0 V?

Thanks for the replies! So basically build something like this? https://iwistao.com/products/iwistao-hifi-ac-power-supply-ac15v-isolation-sealed-toroidal-transformer-15w-audio-dedicated-whole-aluminum-casing What would I do with the third pin/wire, that in my case ends up going through (what I...

For years I have owned this apparently very rare Jecklin Transdyn 2, that I got together with some other old gear. However, I don’t have an AC-AC adapter for it, so I have never been able to check if it even works. I know/understand very little about electronics, so I need some help: what do...

Now I've made it through all 23 pages... I've had my Clears for almost three years now, and I currently do not experience any pops or other issues even when listening at levels I know I should not be at. I drive them with a Little Dot MK III tube amp, sporting a pair of 6N30P-DR tubes. However...