Search results

It has single ended rca in, no true balanced inputs… the rca input may be some kind of floating ground or similar, but definitely not differential balanced like XLR input

This does the exact same as the lead from France… cck is irrelevant to its use, we just the cck3 in cars to charge the phone

Or just create a lead from two usb leads… works very well…

Not sure what you’re actually trying to say? Mine do 300wrms x2 and 1k into 4ohms as measured on an ap555, not based on any particular amp module, Audiotec Fischer bought the rights to use the amplifier design and then built the rest of the circuit around it , it’s not using purifi amplifier...

That’s the same difference just with switches instead of unplugging a banana plug or seven Manufacturers should make a solo menu so you can do it with a remote, it’s a given in all aftermarket dsps, why not put it into the AVR software, it’s a dsp after all at its heart

I’ll be impressed when I can input a test signal and route it to any channel or combination of channels as I can with most dsps, that way I can measure phase with Smaart without disconnecting speakers as I have to now

Well I bought myself an smsl DL100, and a few amps of the finest Brax persuasion… including two new rx2 pro with digital input and purifi eigantakt technology inside

This is an awesome dac and also a kick ass headphone amp… over budget at £180… but it’s amazing for that cash

I wasn’t clear, it was analogue rca we could distinguish one cable from all others

The rca was analogue not spdif coax, sorry that wasn’t clear… I would hope you’d realise that… as a loopback test with different coax digital cables would show no differences

We did a blind abx test with coax vs optical and it was indeed indistinguishable… I was curious and we used a topping d10s to feed both into the same Dsp and switch randomly… zero difference We tested a couple of dsps that people said had different sound characteristics… yup… zero difference...

Just drunk… but not legless!

I’ll just leave this here… I don’t possess them yet, but pick them up on Saturday when I’m at HQ doing some training for a uk dealer that’s a whole heap of flagship amplifiers… 8ch of power around 300wrms each channel The mx4 pro will be used with analogue (it will take digital inputs just...

It literally is lossless, it simple takes usb in and converts it in a lossless manner to spdif coax and optical

The 2024 version is now available after a little digging

No different, resampling if any is done will be done on both the motherboard spdif and the usb digital output

Correct, zero point in adding a digital conversion

This is being made far more complex than it needs to Channel 1 left front speaker Channel 2 right front speaker Channel 3 and 4 to the subwoofer Channel 1 and 3 will be fed by a splitter from the left rca and ch 2 and 4 will be fed by the right rca… The amp takes care of combining left and...

‘People’ didn’t stream it for the most part… he and his army of computers did… that’s where he came unstuck

I have a nas and will have approx 500gb of the start of my stored collection, it will also live on my iPhone as I bought the 1tb version so I had plenty of space, primarily listen to Apple and tidal also