Search results

Bass has the most dynamics. And bass dynamics are the hardest to reproduce. Many speakers can accurately recreate the treble, midrange and upper bass. Capturing the dynamics of low bass is far harder. You need multiple large drivers, subwoofers or both.

My wifi averages 450 mbps throughout the house. I don't think speed is the issue. I have two different mesh systems on hand. Same problem with both.

I don't have this issue with my Wiim Amp or my Wiim Pro, although they are used in different systems. They do have a different but equally annoying issue. When using Apple Music (whether from my laptop or my iPad) via Airplay, both consistently drop the signal when changing tracks on shuffle...

I was an earlyish Mini adopter, like it enough to buy another, and liked them enough to buy a Pro and an Amp, which have basically replaced my previous very complex Anthem and Denon systems. I recently moved houses and didn't hook up the Minis for a couple of months. When I did they updated...

I use a tiny cheap Dewalt DW055 around the house and find it just as hard to believe a more expensive laser would be more accurate as I do to believe a more expensive digital cable would be more accurate. Is such precision necessary? I suspect not given the natural head movement of even the...

I'm not sure that comfort is totally subjective. After decades owning HD580s and putting up with their clamping, one of the things that tempted me to try the r70 was the consensus that they were lighter and less squeezy. Which was the case in practice. I agree that the R70 'measure' better...

I haven't owned the R Meta, but I have owned the the r3s, the Ref 201 and listened to the previous Ref 1s. The Seas is right up there with them.

I'm astonished people think this speaker is worth a 53 page thread, especially given the source. Like yourself I have vivid memories of Mr Ritchie's theories through various DIY forums over the years, as well as a few direct interactions with him when this coincided with my interests (mostly...

I doubt the expense of 9 KEF coaxes would be rewarded. Given the USP of the 901s was front back radiation, I suspect a good open baffle dipole would be the modern equivalent

MiniDSP products tend to have a longish product cycle unless something new and shiny comes along. In which case they release it first as a processor. Nothing new and shiny is on the site apart from different input and output options so I suspect no new SHD amps for a while. Given the...

Well, that's the SINAD problem isn't it. Given that the noise level of a room is vastly worse than the SINAD of even the worst electronics, does it matter?

I've been using Digital EQ for many years, starting the now venerable Behringer DCX2496, moving on to better pro units such as dbx driveracks, then various MiniDSP units and auto EQ systems. Measurements clearly showed the early units added noise, and in the case of those with analog inputs so...

Good decision. I’m unable to tell an iota of difference in any amp measuring above indecent. But room EQ makes an obvious audible (and measurable) difference. I’ve been using Minidsp products since they first came out, and still use one of their DSP amps. If you are prepared to do a bit of...

The Neo is very good, but it isn't an AMT. It is a planar magnetic. I've had both the Neo and now an AMT (AST2560, same as the Bordeaux) in my DIY speakers and slightly prefer the AMT both objectively and subjectively. Not sure if they are better than regular tweeter, but I run them dipole.

When Rooning, I use Sonos over Airplay. Sonos streaming adds a buffer to avoid dropouts and glitches. Despite having very good wifi coverage, I still get occasional dropouts using Airplay via Roon (although not Airplay via Apple Music). With Sonos these glitches are considerably less.

If you can measure properly, you could do room EQ below 200Hz or so, but if you can't I also wouldn't do anything other than maybe experiment with a shallow high shelf filter (5-7000k, -3dbish, .5Q). Plus they need subs below 100Hz. It's interesting that the CDM1s from 1998 measure vastly...

It doesn’t seem to in my case. I had no issues when I was using the optical out of my Wiim to my DAC via Roon. But I’m now using the aux output directly into active speakers and getting an audible (albeit low level) glitch after every track. It doesn’t drive me crazy, but it does bug me...

You are in the value sweet spot. There are a bunch of extraordinarily good value speakers around at the moment, most of which have been mentioned above. T5V, 305P, KRK G4, Kali LP6, Vanatoo. You might be able to get the bigger bassier versions for your budget. Although I don’t think you...

Does Gapless work through the aux output, or only the Toslink?

https://wiimhome.com/Technology Scroll down to the Adaptive EQ section.