Search results

  1. U

    HouseCurve iOS app with GEQ?

    That makes complete sense. While there's no way to control Gain or Q per XYZ frequency in this specific receiver, I was able to do a sweep with EQ off and then based on the initial readings (the gray line), adjust the GEQ accordingly and the vocals are much better and far less bright and tinny...
  2. U

    HouseCurve iOS app with GEQ?

    The grey line is the initial measurement with EQ completely off. You bring up a good point though with the blue and magenta colors. Now I don't know which is which but after hopping back into the app I can see that the blue is the estimated curve response and the magenta is the current response...
  3. U

    HouseCurve iOS app with GEQ?

    Complete noob here. I don't yet have a DSP but figured I would toy with the HouseCurve app in the interim. My Yamaha RX-v383 is a little baby and only allows me YPAO PEQ or REQ adjustments at set frequency intervals between 63hz and 16khz Was curious if I could somehow translate from the PEQ...
Back
Top Bottom