Search results

  1. W

    Marantz AV10 AV Processor Review

    Not sure but it's rounded edges and very thick gauge compared to any other amp/preamp I've ever owned. No I didn't open it up I'm sure there are photos on the net.
  2. W

    Marantz AV10 AV Processor Review

    Just got my AV10 a little over week ago coming from a 8805A. The AV10 used some seriously thick gauge steel for the case. I was very surprised it's NOTHING like any other product of theirs I've ever seen.
  3. W

    Marantz AV10 AV Processor Review

    My main speakers are the same Paradigm 100F’s with the almost identical sensitivity. I only experienced this once I changed to the M28 amp using XLR cables from a Marantz 7055MM amp. I keep all things the same when switching to a new amp and that’s when I could clearly tell the center speaker...
  4. W

    Marantz AV10 AV Processor Review

    From Paradigm's site Sensitivity Room / Anechoic 94dB / 91dB That's what I did is use a RCA cable for the center channel only. But before its level is set, it's clearly louder than any speaker in my setup.
  5. W

    Marantz AV10 AV Processor Review

    Thanks for the information. On the NAD M28 (using XLR's) with my current Marantz 8805A on the center channel I'm getting a much elevated sound level when calibrating it using MultiEQ-X. It was a trying to reduce it down to -12dB which is at its lowest parameter. It shows it as around -12.38dB...
  6. W

    Marantz AV10 AV Processor Review

    Curious to all you that may understand these things more than I. I'm picking up a AV10 and have for my amps two NAD M23's for my main speakers and a NAD M28 for my Atmos speakers. Based upon the measurements would you use XLR cables or RCA cables to the amps?
Back
Top Bottom