Search results

I use the Isoacoustics Aperta 200 isolation stands (Here), and they sit on top of my SVS PB-3000 subs, with one sub on each side to my front left and right. It works out nicely because the height of the subs puts the R6 tweeter right at ear level when I’m sitting down. I also had limited space...

I have 3 X R6 for my front setup and they sound fantastic...Very dynamic. They match up nicely with my dual SVS PB-3000s at a crossover at 90Hz (according to Dirac Live). R6 is basically an "R7 lite" without the rear port so they don't dig as low in the bass. Not a problem if you're using...

Erin was asked about this in a recent livestream here and compared the two configurations by looking at KEF's white paper.... In short, he said you could go either way (assuming the use of a subwoofer)... Slightly better dynamic range and slightly lower distortion with the R6M, but slightly...

Been thinking about getting these for front L/R in vertical position (with subs). As someone who is new here and doesn't really understand the graphs, how well do these measure as L/R in vertical position, as compared to lets say the R3s?

This is per their manual so you're right in the minimums...

How do the R3's sound on top of the subwoofer like this, and with the ISO stands? Generally, are there impacts to sound quality? I'm thinking of doing something similar with my setup and placing them on top of dual PB-3000s with the same ISO stands. Thoughts?

FWIW, I have a very similar set up as you. I have a 3.1 setup also with the R3's and R2c paired with a Denon x4500h. The Denon had no problems playing the speakers. Eventually, I bought a 3-channel Monoprice Monolith 200watt per channel amp, but to be honest I didn't really notice much of a...