Search results

who knows but if that is the case it sure is misleading the way they wrote it imo

Strange, in the other thread Fosi themselves mention the supposed 0.5W standby power usage. Even halved that is a factor of 10. This was after the 10 minutes where it turns of in auto mode right? Anyways would be great if others could check out the idle/standby power usuage as well.

Wasn't standby power supposed to be 0.5W? I assume the "toggle set to Auto but its OFF" would be standby right?

Good to know about the X-max, in this case i could possibly get away with using a stereo class d amp like a fosi v3 or something (i think). They are often used in near-field, how do they perform at around 3-4m distance? And somewhere i read that people use them below a coffee table in near...

Thanks for your insight, i am not really worried about the sensitivity in regard to the max volume as i don't really listen that loud. The sensitivity would have been useful to figure out if i could get away with using a receiver with +-10 dB volume control to directly run the RiPol with a...

Great looking build! Am thinking about building one myself, do you have any idea what the sensitivity is?

i have had a look through the manual and besides the +-6dB subwoofer trim, there is also the +-10dB speaker level adjustment that one can set even for the sub. Other level adjustments i found are tone ones with once again +-6dB for bass, but that should probably stay unchanged. Maybe i'll just...

thanks for clarifying! i knew that the overall volume would be set by the receiver but was worried that the base volume of the monoblock would be too high to align the volume of the sub to the main speakers. just recently found out about these amps because i read the review here and for my plan...

The Yamaha V6A would fit the bill it seems, as it would allow me to add another sub and eventually expand to a surround setup. One thing i have been wondering is if i could use a fosi v3 mono as the amp for the diy sub i plan to build. I know that the Yamaha can handle the crossover but how...

since the ultimate goal is HT i guess i'll go the receiver route thanks for clarifying that. so if i get a receiver which does the crossover for me i could just get a power amp for the sub i want to build and connect the Versacube i already have (which has a mivoc am 80 sub module) using the...

Room correction is admittedly pretty wonky as far as my setup goes. I generated PEQ filters with REW and then used a PEQ to GEQ converter script i found on github to incorporate the filters into wavelet which is running on my shield TV, which is of course connected to the TV. I guess another...

Greetings everyone, my first post here. Please be patient and if i somehow missed this being discussed elsewhere, please tell me. (or if this is the wrong place) I am currently running two KEF R3's with a Yamaha R-N301 and a Versacube Sub connected via high-level input. Input is optical from...