Search results

  1. D

    Loxjie A40 all in one amp 2024

    I agree, which is why I'm not too concerned. Eventually they will be powering my Tannoy SRM-12Bs as soon as I can rebuild the crossovers.
  2. D

    Loxjie A40 all in one amp 2024

    Has anyone else had this unit intermittently mute audio? I have mine connected to a pair of Elac BS-41 speakers and the audio intermittently cuts off at high volumes. Usually at 50 or higher (Goes up to 60).
  3. D

    Op Amp Rolling

    First thing there is absolutely nothing wrong with the NE5532 opamp. The only place where it's bettered is with regards to common mode rejection, including power supply rejection. This is why Aiyima's recommended upgrade for their amps is the LM4562 because it has 120 FM cmrr (as opposed to the...
  4. D

    Loxjie A40 all in one amp 2024

    I've had this unit several weeks now and it's great. It's my living room system, hooked to a WiiM pro coaxially and my 5O" TV optically. I'm running it into a pair of Elac BS-41 speakers and a Monoprice 12" amplified sub. Crossing over at 50 Hz. It plays loud and sounds incredible. The stereo...
  5. D

    3e Audio TPA3255 Amplifier Kit 480-1-29A Review

    I routinely service multi megawatt UHF TV station transmitters, so I well know the value of proper cooling. These are happy as a clam.
  6. D

    3e Audio TPA3255 Amplifier Kit 480-1-29A Review

    The quarter inch thick aluminum plate that 3e uses as a heatsink barely gets warm! Probably because it's open to the air as opposed to being in a little closed box. But if it bothers you they are even happier this way. The power supply is convection cooled and sits on the floor. It's also barely...
  7. D

    3e Audio TPA3255 Amplifier Kit 480-1-29A Review

    Why? I'm simply sitting my modules on the table.
  8. D

    3e Audio TPA3255 Amplifier Kit 480-1-29A Review

    Implimenting this is beyond easy! Two push terminals per channel for speakers, two for + power and ground, and two balanced input plugs (That you have to splice to RCA cords. This took me about five minutes to do, and I shrink wrapped everything. I
  9. D

    3e Audio TPA3255 Amplifier Kit 480-1-29A Review

    Running my new mono cards on a ten foot #10 stranded cord from the 50 volt 10 amp power supply. Two feet from the cards the cord splits into two #16 cords which plug into the two mono amp cards. I'm running a WiiM Pro Plus into the amp and Emotiva B1+ speakers. The sound is wide and deep - far...
  10. D

    Fosi Audio V3 Mono Amplifier Review

    Actually it should work just fine. Try it.
  11. D

    Fosi Audio V3 Mono Amplifier Review

    Here's an idea to try: Take ONE of the outputs of your BTL output amplifier and put it through a 1000 uf 35 volt capacitor (With the + pointed towards the amplifier). Connect the + of your speaker to the - on the capacitor and the - of your speaker to ground (the - on your power supply input...
  12. D

    Fosi Audio V3 Mono Amplifier Review

    But I'm not doing that, so why even bring it up?
  13. D

    Tekton M-Lore Speaker Review

    Art and creativity. Are you high? If I'm going to pay a ton of money for a set of speakers they had damn well sound good, and that has nothing to do with art and creativity. It has to do with how well they reproduce music. The fact that many recordings have been mastered on Auratune Super Sound...
  14. D

    Fosi Audio V3 Mono Amplifier Review

    How will they short each other out? All the connections to this board are by insulated connectors and very tight push on terminals (ones that go to power and speakers are both crimped and silver/tin soldered). If you put this in a cabinet then you have two input and speaker connections and I...
  15. D

    Fosi Audio V3 Mono Amplifier Review

    Actually, yes! Been running great for months! Nice and cool too.
  16. D

    The 3e boards are back in stock.

    Both stereo and mono 3e amplifier boards are back in stock at AliExpress. They are selling out fast.
  17. D

    Loxjie A40 all in one amp 2024

    Probably. The fact that this isn't done anymore doesn't mean that caps don't benefit from it, does it?
  18. D

    Loxjie A40 all in one amp 2024

    The vast majority of infant mortality failures are due to electrolytic capacitors. Some don't completely fail but change value, etc. In the analog world we would put a Variac on gear and slowly bring its voltage up for 1/2 hour to form their capacitors. You can't do that with digital, yet the...
  19. D

    Loxjie A40 all in one amp 2024

    Because it's a first use. Electrolytic capacitors need to form.
Top Bottom