Search results

I have a 2.2 system including 2 full range speakers, so I can let MSO calculate the optimum combined response from 4 different sources of bass by only using phase filters. You could try it yourself, I found it quite intriguing. Regarding the delay: I thought the same. The entire signal path is...

Thank you! I'm a fan of your YouTube tutorials. My responses: (1) I'm not using the all pass filters to correct phase response, but to improve the frequency response. And it seems to me that they work for that purpose. You can see it in the graphs too. (2) I tried REW's alignment tool just as...

I think I understand it now, let me fool around in REW a bit and I'll get back to you. Unfortunately I don't have much freedom with sub placement. I already spent a lot of time in REW's room simulator to get a feel of what approximately the placement would do and they're now placed in the bottom...

Thanks for coming back to my topic. I agree the readability is very poor, I can time align the measurents in REW so that there's a slightly better overlap in the phase measurement graphs and post those, but it will only slightly improve the readability. I did not time align them on purpose in...

OK, here it goes: subs only for the 3 LPs

And graphs per speaker:

Here you go, I had to show them unwrapped because otherwise it was just a big mess.

Also very critical for rock music: if you play around with PEQ in that region, the tone of especially distorted guitars changes significantly.

I already did that for the initial measurements, hence my question whether I need to apply FDW. Only for the polishing filters I used RTA/MMM.

Dear All, I've bought a MiniDSP nanodigi, 2 8" subwoofers and a UMIK-1 and I've been experimenting with them for 20+ hours now. For my latest configuration, I have done the following: 1. REW sweep measurements in bass region for each of the 4 drivers for 3 LPs, I used acoustic reference on the...