Search results

.

Nice to see this review and measurements of the RB-1070. Back in 2004, I had purchased a Marantz SR5400 receiver and Paradigm Studio 100 v3 towers and CC-570 center. In 2005, I was at a local stereo shop in central Ohio, and they had a Rotel RB-1090 almost 400wrms/ch sitting there for only...

Yeah, I'm sure I'm not the only one. I am sure that not everyone pays attention to stuff like this though. There probably are some that do. I was just wondering if it could be measured when something approaches or is just present at some position near by versus when it's not there.

Yeah, that's pretty much what I am thinking as well. I'm just curious if that can be picked up by a microphone. Like start with nothing near, then move an object closer at some increments. And yes, I am also tuned in or just pay attention to people's heat bubble.

I have an interesting topic... well it's something I've been fascinated with for many years... I didn't know exactly what section to post this, but this one seemed like the best fit. It's a sensitivity to low frequencies. I'm a basshead (my best car audio system was a Cerwin Vega Stroker 18...

Back in 2004 when I bought my Rotel RB-1090 th use with my Paradigm Studio 100 v.3 with signals coming from my Marantz SR-5400, the audio shop guy said, ok before you go, you have to buy these XYZ (whatever brand) RCA cables. They were actually inexpensive at $70 each 1m set. But I turned to...

Yeah, I laughed for sure. Kicked myself for not thinking to check that the sub was even on. To swap the cord, I had to enter the equipment closet which the entrance to access the back of the equipment was just outside the theater room (out of his sight). Initially when I swapped, I had...

Just a few days ago, I watch Amir's review of this power cord, and it reminded me that I had posted this fun story back in 2019 on Stereophile. AudioQuest power cord review... Real or placebo...? Submitted by AudioTK on March 20, 2019 - 3:30pm This was some interesting reading...