Search results

This SPDIF Reclocker was designed and developed as a solution to issues many customers have faced: SPDIF with interruptions, discrepancies, no sound at all… Until recently, the error margin to receive SPDIF signals was wide enough to accept any kind of signal, whether it was clean or not. DACs...

It seems to be a DAC with a ROHM BD34301EKV chip.

Here are 2 photos taken from a paper catalogue (hence the average quality).

Here is the official image received from EVERSOLO:

Thanks for the review. The DAC level was intentionally limited because as a digital amplifier, we felt it was comfortable knowing that with maximum signal (0dB), and maximum volume, you reach the max power (or almost), without distortion .

The MATRIX ELEMENT P2 uses the ICEpower 250ASX2 module (information collected from Matrix).

Yes, you can connect an active subwoofer to this pre-out RCA output.

Linkplay module accept Airplay, so : Roon -> Airplay -> Wifi Input

We updated the manual. It's the Wifi Reset button. Blinking mean that the Wifi module is not connected.

Hello, Yesterday we made some close listining tests on several devices and we think we know what you hear on your model. It may come from your PSU which is idling. Please contact our after sales service (On our website, My account page)and we will fix it for you.

The BT module can accept LDAC and APTX HD

Yes it can be activated or desactivated into the menu, even for non Wifi version.

We made a firmware that keep the relay always ON after startup. So the outputs will not be grounded anymore when the DAC is Unlock. Unit sold from today will be updated with this firmware. If a customer is annoyed by the relay noise, we suggest him to contact us (open RMA ticket into website...

The click is normal, it's the mute relay that avoid to get pop noise into speakers. It's related to lock status of the DAC. When the DAC do no receive digital signal anymore it's switching to unlock, and connect the relay to ground the DAC ouputs. The relay can be heard near the amplifier, in...

This is a good idea, but at normal listening level the signal is very low into XH connector. For best performances a DSP should always run at line level.

Here's a fresh video review from Mike audio

Hi, You can take a look here : https://www.headphonesty.com/2019/05/balanced-vs-unbalanced-audio-connections/

You have explained it perfectly. This is exactly what is happening with the EIGHT.

Hello, Our in-house amplifier based on the 1ET7040SA is under development. We are developing a special dedicated power supply, to take advantage of 100% power, regardless of the Ohm load. But unfortunately no release date yet.

Just received it and transferred to the after sales team, they're gonna contact you asap.