Search results

consider getting rid of your tube amp. that's what will give u "grittiness" and all other bad things. get solid state (transistor or opamp) amplifier.

blue group - venus hum. I simply froze.

Electronics die, sometimes suddenly. Hence, I keep a backup amp - Aiyima A07 :)

hard to disagree. Weak sequel. No agent Smith - new actor. Much milder villain - Counselor. Bunch of weak new young characters - give me back Mouse any day now! No Oracle. But.... Merovingian! :D "Wake up, sheeple! This is for using children!"

BrzHiFi is a company known to butcher good components. I wouldn't buy anything unmeasured from them.

Purifi will run circles around PA5.

could it be that AO200 is simply "cleaner"? also, I had ELAC B6 (no .1 or .2) - first version. They are "not great" to put it mildly. Dialog in movies was impossible to decipher.

if u read A130 review, Amir had to equalize them. So not so perfect.

I support that. Prednisolon will help. Also, for blocked blood vessels there is a simple homemade remedy: crush 1 lemon and 1 full garlic in the mixer (or slicer) put it into 1 liter of water and heat til it boils. steep for 1 hr or more. filter. drink up to 3 times a day. do some physical...

"nuke it from the orbit" :D

They list "Output impedance 100 Ohm". not sure if it's for XLR outs? Or headphone out. hmmm.

there are RCA to mono TRS plugs available anywhere - you will need two. something like these: https://www.amazon.com/Adapter-Converter-Connector-RFAdapter-Subwoofer/dp/B088ZL89VJ/ They worked really well for me. As for "lost 4V input signal" - don't worry. PA5 will clip at 2.6V - its rated input...

There is no limit for perfection! The more - the merrier! :D I mean, who's to stop me from buying a new ones, when I'm bored with my old ones?

I agree on 3rd one - A07 stomps all over PA5. And the bottome line - save a little more money and get a Purifi or nCore, or don't save - get A07. PA5 works fine for my speakers JBL A170.

All-in-one from SMSL to compete with Loxjie A30... Built-in power supply, no optical input, no remote control - big minuses. listed SINAD 86dB - decent.

thx for clarifying. Maybe try feeding your sub via that small 3.5mm to RCA in the back of A07? Or split RCA inputs to A07 and sub? I have not very good Monoprice sub and it simply refused to work over speaker inputs, RCAs were fine.

is your Sony 100W subwoofer powered? or u r powering it via A07? I don't recommend powering any subwoofer via A07. Your next power supply will likely fail as well.

Update to my review of PA5 and comparison to A07. 1. I noticed there might be issues with E50 Pre volume going to PA5 - do not set it to 0.0dB, set it to -4dB max. 2. I ran ReplayGain analysis of my test track and applied it - with values being track gain -4.89dB, track peak 0.976 3. After these...

With these findings u never want to run E50 to PA5 in DAC mode then. Only in Pre mode with -4 to -10dB setting. The same does not apply to my E50 to L30 connection, as L30 can accept more than 2Vrms over RCA. The question is - should I feed it with TRS-balanced-to-RCA cables? And would be the...

I have a question for experts about incoming voltage and volume from E50 to PA5 over balanced. I tried googling but could not come to a definitive conclusion. Pls feel free to challenge/update any points. 1. E50 supplies peak 2Vrms over single ended (RCA) and 4Vrms via balanced -according to...