Search results

  1. P

    Behringer A800 Stereo Amplifier Review

    I have been having this huge 18 incher subwoofer sitting idle for two years, now it s working and giving that kick to my sound image. !
  2. P

    Behringer A800 Stereo Amplifier Review

    Don t do absolutely anything, the ATC is a very good monitor, no electronic X over needed whatsoever, spend on very rigid, heavy, damped, de coupled stands, for my two way bookshelf l m using Yamaha studio stands, high, perfect. Unfortunately no more produced, l filled them with sand. I m using...
  3. P

    Behringer A800 Stereo Amplifier Review

    What electronic x over are you using, loudspeakers ???
  4. P

    Crown XLS 1002

    Solved!!!! It was some cabling problems. And connection issues. See pic. Thanks to everybody.
  5. P

    Crown XLS 1002

    Darn l will set my main pre amp tomorrow.!!!! See pic. His output could drive a pair of speakers !!!!!
  6. P

    Crown XLS 1002

    Can l set for example fixed volume on RCA out - 20 dB ??? My Behringer s are connected via XLR - so l m in XLR + RCA mode, I am listening, main volume is -35 dB enough that l can talk to my wife in our 100 sq Mt salon, music is more than background, the Crown doesn't even show green led...
  7. P

    Crown XLS 1002

    Yes I can regolate out put on RCA , where the Crown is connected, differentially, but a pain in the neck to enter such regulations, horrible firmware. I have not succedded right now.
  8. P

    Crown XLS 1002

    My sources are Cd player, smsl ao100 dac, tidal too.
  9. P

    Crown XLS 1002

    Another reason could be the following: as I said, I m driving the two huge floorstanders with two bridged Behringer A800 s, such loudspeakers are 90 db sensitivity, so the volume get pretty loud at 30 db as my Topping pre amp shows, I can t pull it up not much more, so not enough signal gets to...
  10. P

    Crown XLS 1002

    The sub is a Behringer Eurolive 1800 s. It's a mistery, when l bought it , 2 years ago, and never used again, back then l tested it and my house was shaking, don't remember how and what equipment l connected it with. In this actual configuration the led - meters of the Crown stay with just one...
  11. P

    Crown XLS 1002

    I meant that in bridged mode, the frontal left pot controls the volume. Right pot is inactive. Amir tested the Topping pre, only in XLR mode, if l m not wrong, tomorrow l will reverse the output cables. Sub is a passive 18 inch Behringer.
  12. P

    Crown XLS 1002

    My system right now, Topping pre 90, two Behringer A 800 s in mono, each to one channel, R+L, out of Topping XLR+RCA, RCA goes to Crown XLS 1002, brand new, bridged, low pass at 200 hz, going to a Behringer 18 inch subwoofer , sensitivity on the Crown is 0.775, but subwoofer volume is very low...
  13. P

    Behringer A800 Stereo Amplifier Review

    Yes but you would need four mono amps.
  14. P

    Behringer A800 Stereo Amplifier Review

    No. You have to use two stereo configured a800s. Amp A goes to the woofers. Amp B goes to the tweeters.
  15. P

    Schiit Freya+ Pre-amp Review

    Please test an Audio Research tube pre amp. Thanks.
  16. P

    Crown XLS1002 Pro Amplifier Review

    Hey Ma'! Look what l found in wha (o) rehouse C of my humble villa, can l solder Kimber . Qued . Nordost cables here ???
  17. P

    Behringer A800 Stereo Amplifier Review

    Send them all back. Production numbers,?
  18. P

    Behringer A800 Stereo Amplifier Review

    At the moment, I am using two A800 s in mono---left right channels--on a floorstander, passive x over inside. volume full to eleven, no noises.
  19. P

    Behringer A800 Stereo Amplifier Review

    I have a multi amped system. Balanced pre : Topping pre 90, smsl balanced dac , Electronic X over, 3 Behringer A800. Bass-mid-highs. All connected via XLR cables. No noise whatsoever, volume pots are full on on bass and MIDs, two o clock on highs. Very silent system. I hate components noise. (!)
Top Bottom