Having a small difficulty here. I finally got the back panel in, bolted everything together, connected the wiring harnesses, and connected the mains and the speakers. The back switch on the Ghent IEC socket illuminates, but not the front on/off indicator. When I power it on from the IEC I hear a small click which I have isolated as coming from the SMPS. Any ideas what this could be? i did remove the standby switch, my understanding is that just physically removing it was all I needed to do--nothing to wire under the chassis to bypass it in other words. So I don't think I had to do anything other than provide the nAMPON and the nFATAL wired connectection between the J4 on the Hypex and the J3 on the Purifi which I have done. I am questioning if the connections are good on the 3m connector, though they did pass continuity testing.
Since the fit is so tight between the Eval 1 and the back panel, I am also wondering if there could be some kind of short being introduced there, and how I would determine that.
Any troubleshooting ideas would be appreciated.
Also, since I have put line voltage through the unit (I've now disconnected it) how long before it's safe to do anything near the SMPS after all power has been disconnected? Some units, as understand it, retain current in their capacitors for a time, and I want to be completely safe in this regard.