You are, as it is now customary to say politically correct, "a little mistaken."
We will leave the cables from TARA Labs to the audiopsychos audiophiles...
And simple music lovers use "warm-up files" to speed up the OpAmps that are installed in new audio devices into nominal operation mode.
This...
And if you download a file "Cascade Noise Burn-in" to warm up from TARA Labs and play it on repeat for two weeks, then the DAC will please you with even better sound.
;)
Yes, I have a first-generation D300, on which the MCU firmware 1v0, 1v1 and 1v11 were tested.
How it will behave if I install the firmware of the MCU 1v21 is unknown...
Unfortunately, you are very wrong.
The D300 is flashed with TWO different firmware and with the help of TWO different utilities.
Using the utility XMOSUSBDACDfu.exe we are flashing XMOS USB DFU (file SMSL_D300_USB_DFU_v1.3.bin).
Using the utility ispV2.4.exe we flash the MM32F103 processor...
I realized that you haven't read this topic from the very beginning.
Otherwise you wouldn't have these questions.
Everything is described in detail, starting from here.
The D300 has such a feature: it is possible to lower or increase the version of the MCU by flashing without the risk of...
The firmware MCU v1.00 works fine on my USB firmware v1.30.
I had to solder out a chip with a corrupted USB firmware, flash it in the programmer in v6F2 and solder it back.
After restoring the work of my DAC, I flashed the USB in v1.30 on top of v6F2 and flashed the MCU with a serviceable...
No, I didn't change anything in the D300.
I used op-amps OPA1656 when modifying the BRZHIFI 3255XLR amplifier .
There, these op-amps are used as a pre-amplifier with a gain of = 3.2
If the manufacturer erases the marking of the op-amp, it means that he has installed the cheapest op-amp, such as NE5532 or JRC2068.
At best it will be OPA2132...
Therefore, feel free to install all three OPA1612 op-amps and you will be happy!...
...And if you like the imitation of "warm tube...
Sorry, but no one will be able to tell you, since the marking of operational amplifiers has been specially erased by the manufacturer.
This is usually done when operating amplifiers of medium or low quality are installed...
:(
Here in this message the firmware of the MCU version 1.0 is posted.
Here Here in this message the firmware of the MCU version 1v1 and the firmware of the DFU (USB XMAS) version 1.3
For the power supply compatibility:
1. ORIGINAL power supply = CDXS438-36 -> W=81,5mm / D=127mm /H=38mm
max output ripple = 360mV - 4,2A
The actual unit you can look up (at least on mine) is here: https://www.fs-czx.com/?kg/73.html
2. HIFIMEDIY power supply = SMPS300RS -> W=100mm /...