You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
-
T
Finished my speakers today. The 1cm 3D printed front is sealed onto the 9mm wood front. The wholes are for extra screws (mainly for the...
-
T
It was actually purely for aesthetic reasons. I wanted them to look relatively slim in the ceiling. Calculated QTC via Winisd is little...
-
T
I re-measured the enclosure and the volume is very close to 4l with very generous internal bracing (I used 12mm birch plywood for making...
-
Loading…
-
Loading…