TimoJ's latest activity

Using speaker terminals to connect extra subs could work (since Dirac probably could EQ it), but you need to add passive high bass...

Not sure why you would use 100Hz? I use all speakers up to 150Hz and both subs (front/rear) 100Hz. And that 100Hz sub limit is only...

It will, that 100Hz lowpass filter is on my Crown XLS amps, not ART or AVP/AVR. I tested with higher filter values but 100Hz seems to...

Here is LFE channel REW measurements with ART correction, 7.2.6 setup. First picture has all speakers and two subs active. Next one has...

ART also doesn't seem to EQ subwoofers like regular Dirac does, it uses other speakers' support to do that. I'll have experiment what...

How is that done? Since ART does bass management and splitting/filtering bass and LFE to different subs how can you clone LFE to other...

First sub plays LFE + bass managed signals from other channels + ART cancellation signals for different channels. Other subs play...

What is LFE in your opinion? Isn't LFE just one of Dolby/DTS channels? So I don't understand what you are talking about.

But they send bass managed low frequency signals to all subwoofers and add ART correction signal on top of that. What is there to...

Full LFE signal goes only to first subwoofer.

Maybe you don't fully understand how ART works and what it does with support speakers/subs? It's not about going below 20Hz (and ART...

No matter how good L/R speakers are, they will still benefit from support speakers and/or subwoofers.

I use ART (also) with 2 just speakers and it does work much better than regular Dirac. I think I earlier posted here REW measurements...

That appears to be the case, at least for now. But other subs' level depends on frequency response (in your room) of subwoofer1. So...

Are you using your AVP's LFE filtering or subwoofer's built-in lowpass filter?