Recent content by Slyceth

Just imagine a bargain bin logitech speaker: (and any other passive speakers I might pick up in the future that just have the 2 simple wires) And the current receiver I'm looking at is the Denon AVR-X2700H DAB, but honestly I think most receivers will do the trick, the secondhand market is...

So to conclude, the best option would be a secondhand receiver. I found a Denon AVR-X2700H DAB for 360, would that do the trick? So for expanding the speakers, say I bought for example a pair of budget speakers that have 1 plug that normally goes directly into the pc audio port, but instead I...

Thank you for the recommendations! It seems I can get the SMSL D-6 for 170, and the Topping E50 for 200. I have just one more question to get the full picture of the set-up I'll end up with. I'll be making a lot of assumptions and I hope you can correct me where I'm wrong? As I understand, the...

Thank you! I bought the Dopping D10 Balanced. It works perfectly, only now I do not know where to connect my SVS SB-2000 PRO Subwoofer, connecting it to S/PDIF out only makes the subwoofer give off a hum, and the amplifier only has a S-12V trigger output. Do you know how I can connect it? Does...

My sincere apologies, I'm back to clarify. What I need is digital in -> Left+Right XLR out. No audio recording. Thank you for your patience!

I've looked at several devices, and since I have a decent amplifier, I wish to use the XLR inputs from it to connect it to my PC/media station. One device that seems to do everything I need is the Cosmos ADC/ADCiso, but I don't know if it's meant for daily music consumption (it says it's for...

Line outs into the amplifier? So I can't re-use the existing amplifier in some way? I need a brand new surround amplifier? Can't I use my existing stereo amplifier, and buy another stereo amplifier and a single amplifier (2+2+1) or (2+3) to get to 5 channels?

I'm interested in upgrading my set-up to 5.1 Surround. Would that be possible? I still have the AUDIOPHONICS MPA-S250NC XLR Class D Stereo Amplifier Ncore 2x250W 4 Ohm, the SVS SB-2000 Pro and the LS50 Meta's can I re-use these? Can I just buy 3 more LS50 Meta's or can I also buy 3 more active...

I've updated my firmware immediately after you commented this. Everything was back to normal for the weeek until 1 minute ago when it happened again. I also heared a random spark noise from the right speaker that worried me..

I got 2 LS50 Meta's and a SB-2000 Pro, hooked up to an Audiophonics MPA-S250NC XLR and RME ADI-2 DAC, and watching video it starts getting distorted after a couple hours of playing. It used to be fine for months, and then it happened once a week ago, then another 3 days ago, and today it...

I got 2 LS50 Meta's and a SB-2000 Pro, hooked up to an Audiophonics MPA-S250NC XLR and RME ADI-2 DAC, and watching video it starts getting distorted after a couple hours of playing. It used to be fine for months, and then it happened once a week ago, then another 3 days ago, and today it...

My bad, that's not what I meant, I mean the sound sounds kind of flat on the higher tones, the bass is fine though.

Alright, so apparently to solve that I need to stay on 48 Khz. I had one question left though, how do I test my ears for the optimal Parametic EQ setting? Is there some kind of audio I can listen to like on each of the 5 frequencies, so I can press a button when I can hear a beep to optimally...

It's set as default, but certain games don't have any sound at all when I have the sample rate above 192 kHz

Well the big problem is that most (older) games do not have any sound.. It was fine before I installed the new drivers. Do I lose any quality having no drivers?