RandomEar's latest activity
-
I had exactly the same experience - not with the Truthear Zero, but with the new 7hz Zero 2. The Zero 2s have terrific measurement and... -
RandomEar reacted to Rja4000's post in the thread Topping D50 III DAC review and measurements with
Like.
Also, because i know some are looking into this, here is a 997Hz Sine wave played at -90.31dBFS through the Topping D50 III in 16 bits... -
RandomEar reacted to Rja4000's post in the thread Topping D50 III DAC review and measurements with Like.
Here is a review and measurements of the recent Topping D50 III DAC The D50 III is a small DAC. From above, it looks like a square of...
-
BT remote works very well. Response is instant and accurate and so far no non-response to a button press . Its nice to be in the room...
-
D50 III SINAD 44.1 kHz 4V TRS output TosLink input measured with RME ADI-2/4 Pro SE and E1DA APU, using Audio Precision APx 500 Flex...
-
RandomEar reacted to Rednaxela's post in the thread 3Blue1Brown video on Transformer Neural Networks (like ChatGPT) with Like.
Thank you for the tip! I liked the video so much that I'll be watching the entire playlist...
-
RandomEar posted the thread 3Blue1Brown video on Transformer Neural Networks (like ChatGPT) in Member Area.Youtube creator 3Blue1Brown published an interesting and well crafted video on the inner workings of transformer NNs like ChatGPT...
-
The spins of vendor, Erin and Amir:
-
RandomEar replied to the thread KEF R11 Meta Tower Speaker Review.Kef does offer basic spinorama results + impedance in their whitepapers: R11 [1] R11 Meta [2] I honestly can't see any major...
-
-
RandomEar reacted to gwing's post in the thread Adding Ethernet cable to Router not to a Switch with Like.
The sound should be completely unchanged - unless you count possibly adding hum to the sound system you connect that ethernet wire to.
-
RandomEar reacted to MaxwellsEq's post in the thread Adding Ethernet cable to Router not to a Switch with Like.
Ethernet cables, switches, routers can not have any effect on sound, unless they are faulty or wrongly configured, in which case you get...
-
RandomEar reacted to JakeK's post in the thread How good is bad? (Raspberry Pi 4B headphone output DAC review) with Like.
I didn't make any notes so I can't remember exactly but I think I did try it at different volume levels. Possibly if I had known how it...
-
RandomEar replied to the thread How good is bad? (Raspberry Pi 4B headphone output DAC review).Are you sure you were not operating above 80 to 85% of volume? Otherwise, you would have heard clipping, which - to be fair - is a form...
-
RandomEar reacted to Linards's post in the thread How good is bad? (Raspberry Pi 4B headphone output DAC review) with Like.
Hi, Guys! A short intro: I have been following ASR for last 4 years, since friend of mine showed this forum and somewhat initiated my...
-
Price
