rafaunivega

Dan Clark Audio Noire X it's rated at 13ohm flat impedance, needs high current on low gain. Audeze LCD-2 Closed it's rated at 70ohm, try...

That was the first symptom with my DX5 II. When I tried the Arya Stealth again on 4.4, the left driver died. Then I tried the other...

One day left channel started to crackling/popping on XLR output with Arya Stealth, then left channel volume lowered. Tried with Arya...

4.4mm worked fine for me cause i left an 4 pin XLR adapter plugged. In the 6.35mm SE an 3.5mm adapter always plugged. Everything worked...

I have tried to modify my first post to clarify the error I see being interpreted from my words (English is not my native language)...

It's not a big deal, I can turn it on and off with the remote control or the button on the panel. The USB trigger doesn't work for me...

To simplify: I would like it to have an option to enter sleep mode 5 minutes after turning off the PC, but not to enter sleep mode every...

Hello, I only find one drawback to the Luxsin X9, and that is the Sleep function. I am used to DAC/AMPs going into Sleep mode a few...

I just received an email from Topping telling me that the person who helped me the first time made a mistake. They won't pay for the...

The ground of an single ended can short into the negative of a balanced. When both circuits are open, no problem. When headphones are...

A possible situation that comes to mind: Firmware update -> Factory reset without advice -> HPA ALL enabled -> Problems if BAL & SE...

Thankfully, but they were tortured by the DX5II. Condolences for your headphones. Good luck with your refunds.

Your headphones survived?

Good news for those who have their DX5II without distortion, imbalance, popping, crackling, humming, or other problems... You're a lucky...

2506573188 july 23 2025 Topping Store